Teledyne Everywhereyoulook BLZZRD, Installation And Operation Manual

Page: 42 / 241

BLZZRD ™ Portable Refrigerated Sampler
Section 2 Installation/Preparation
2-8
2.5.2 Installing the 4-Bottle
Kit
To install the 4-Bottle Kit (68-2970-002):
1. Attach the distributor arm to the distributor shaft under-
neath the sampler controller. Note that the metal shaft and
arm are keyed to ensure correct alignment. Secure the dis-
tributor arm with the knurled nut. See Figure 2-2.
2. Refer to Figure 2-2. Attach the 13 inch (33 cm) discharge
tube (Teledyne ISCO Part Number 60-2973-054) to the
bulkhead fitting. Route the tube over the stainless-steel
tube holder.
3. Route the other end of the tube through the spring on the
distributor arm. Then, place the end of the discharge tube
through the opening in the end of the distributor arm. The
end of the tube should protrude below the arm
1
/
16
to
1
/
8
inch (see Figure 2-2). If too much tube protrudes from the
arm, it can catch on bottles and jam the distributor arm.
4. Install the 4-bottle adapter plate in the refrigerated com-
partment. The bottom of the compartment has two posts
that ensure the plate is oriented correctly. See Figure 2-7.
5. Place the bottles into the refrigerated compartment. The
bottles should seat fully against the adapter plate.
6. Close and latch the refrigerated compartment.
Figure 2-6 4-Bottle kits
1
2
4
3
1 Bottle, 5 Liter (

4)
2 Bottle Lid (

4)
3 Adapter Plate
4 Discharge Tube (

2)
1
2
4
3
5
1 Glass Bottle,
1.8 Liter (

4)
2 Bottle Lid (

4)
3 Adapter Plate
4 Discharge Tube (

2)
5 Bottle Stabilizer