Teledyne 400E, Instruction Manual, Page: 277 / 318

Model 400E Instruction Manual APPENDIX A-2: Setup Variables For Serial I/O, Revision C.3
APPENDIX A-2: Setup Variables For Serial I/O, Revision C.3
Table A-1: M400E Setup Variables, Revision C.3
SETUP VARIABLE NUMERIC
UNITS
DEFAULT
VALUE
VALUE RANGE DESCRIPTION
DAS_HOLD_OFF Minutes 15 0.5–20 Duration of DAS hold-off period.
PHOTO_LAMP ºC Warnings:
57–67
0–100 Photometer lamp temperature set point
and warning limits.
O3_GEN_LAMP ºC Warnings:
43–53
0–100 O
3
generator lamp temperature set point
and warning limits.
O3_GEN_LOW1 PPB 100 0–1500 O
3
generator low set point for range #1.
O3_GEN_LOW2 PPB 100 0–1500 O
3
generator low set point for range #2.
O3_SCRUB_SET ºC 110
Warnings:
100–120
0–200 O
3
scrubber temperature set point and
warning limits.
CLOCK_ADJ Sec./Day 0 -60–60 Time-of-day clock speed adjustment.
LANGUAGE_SELECT — ENGL
0
ENGL, SECD, EXTN Selects the language to use for the user
interface.
MAINT_TIMEOUT Hours 2 0.1–100 Time until automatically switching out of
software-controlled maintenance mode.
CONV_TIME — 1 SEC
0
33 MS, 66 MS,
133 MS, 266 MS,
533 MS, 1 SEC,
2 SEC
Conversion time for photometer detector
channel.
AD_MAX_DELTA
4
mV 1000 1–10000 Maximum reading-to-reading change on
any A/D channel to avoid spike
suppression.
O3_DWELL Seconds 2 0.1–30 Dwell time after switching
measure/reference valve.
O3_SAMPLE Samples 1 1–30 Number of detector readings to sample.
O3_STEP_THRESH % 0.1 0–100 Changes in reference or measure
readings exceeding this threshold are
regarded as step changes.
DARK_OFFSET mV 0 -1000–1000 Photometer dark offset for measure and
reference readings.
FILT_SIZE Samples 32 1–100 O
3
concentration filter size.
FILT_ASIZE Samples 6 1–100 Moving average filter size in adaptive
mode.
FILT_DELTA PPB 20 1–1000 Absolute concentration difference to
trigger adaptive filter.
FILT_PCT Percent 5 1–100 Percent concentration difference to
trigger adaptive filter.
FILT_DELAY Seconds 60 0–60 Delay before leaving adaptive filter
mode.
FILT_ADAPT — ON OFF, ON ON enables adaptive filter.
OFF disables it.
USER_UNITS — PPB 0 PPB, PPM, UGM,
MGM
Concentration units for user interface.
DIL_FACTOR — 1 0.1–1000 Dilution factor. Used only if is dilution
enabled with
FACTORY_OPT variable.
SLOPE_CONST — 1 0.1–10 Slope constant factor to keep visible
slope near 1.
TPC_ENABLE — ON OFF, ON ON enables temperature/ pressure
compensation; OFF disables it.
O3_GEN_MODE — CNST 0 CNST,
REF
O
3
generator control mode.
O3_GEN_SET1 PPB 400 0–1500 O
3
generator high set point for range #1.
0
4402
Rev C.3 9