Tektronix DM 5010, Instruction Manual

Page: 42 / 347

Programming—DM 5010
CALC RATIO— Enables X-B/A calculation.
CALC OFF—Disables all calculations.
CALC? —Returns CALC OFF or the enabled
calculation(s).
DBR <num>—Sets the value of the ref constant.
DBR?—Returns value of ref constant.
LIMITS <num>,<num> —Sets values of LIMITS
constants.
LIMITS?— Returns values of LIMITS constants.
MONITOR ON— Enables SRQ when measurement
exceeds LIMITS constants.
MONITOR OFF —Disables SRQ when measurement
exceeds LIMITS constants.
MONITOR?—Returns MONITOR ON or MONITOR
OFF.
RATIO <num>,<num>—Sets values of A and B
constants.
RATIO?—Returns values of A and B constants.
INPUT/OUTPUT COMMANDS
DATA —Outputs data saved by MONITOR SRQ.
SEND —Outputs data in Output Buffer; triggers, if
necessary.
SOURCE REAR —Selects rear interface connector input.
SOURCE FRONT—Selects front panel connector input.
SOURCE?—Returns SOURCE FRONT or SOURCE
REAR.
SYSTEM COMMANDS
DT TRIG—Enables device trigger function. Instrument
triggers after <GET> interface message.
DT OFF— Disables device trigger function.
DT?—Returns DT TRIG or DT OFF.
ERR?—Returns error code.
ID?—Returns instrument identification and firmware
version.
INIT—Initializes instrument settings.
SET?—Returns instrument settings.
TEST—Returns 0 for correct calibration checksum; 351
for incorrect.
STATUS COMMANDS
OPC ON—Enables operation complete SRQ.
OPC OFF—Disbles operation complete SRQ.
OPC?— Returns OPC ON or OPC OFF.
OVER ON—Enables overrange SRQ.
OVER OFF —Disables overrange SRQ.
OVER?—Returns OVER ON or OVER OFF.
RQS ON— Enables generation of SRQ s.
RQS OFF—Disables generation of SRQ’s.
RQS?—Returns RQS ON or RQS OFF.
USER ON —Enables SRQ when ID button is pushed.
USER OFF—Disables SRQ when ID button is pushed.
USER?—Returns USER ON or USER OFF.
3-4