Tektronix 1730 Series, Instruction Manual

Page: 161 / 258

6–1
Section 6
Maintenance
This section contains instructions for preventive maintenance, general trouble-
shooting, Serial Port and LED Driver diagnostics, and corrective maintenance.
If the instrument does not function properly, troubleshooting and corrective
measures should be taken immediately to circumvent additional problems.
Preventive Maintenance
Preventive maintenance consists of cleaning, visual inspection, performance
checking, and, if needed, readjustment. The preventive maintenance schedule
established for the instrument should be based on the environment in which it is
operated and the amount of use. Under average conditions, scheduled preventive
maintenance should be performed every 2000 hours of operation.
NOTE. Cleaning Rosin:
!
The instrument should be cleaned often enough to prevent dust or dirt from
accumulating. Dirt acts as a thermal insulating blanket that prevents effective
heat dissipation, and can provide high–resistance electrical leakage paths
between conductors or components in a humid environment.
Exterior. Clean the dust from the outside of the instrument by wiping with a
soft cloth or small brush. A brush is especially useful to remove dust from
around the selector buttons, knobs, and connectors. Hardened dirt may be
removed with a cloth dampened in water that contains a mild detergent.
Abrasive cleaners should not be used.
CRT. Clean the CRT protective shield, light filter, and CRT face with a soft,
lint– free cloth dampened in denatured alcohol.
Interior. Clean the interior of the instrument by loosening the accumulated dust
with a dry, soft brush. Once the dirt is loosened remove it with low–pressure air
Cleaning