Tecra M1, User Manual

Page: 201 / 218

TECRA M1
Version
1
Last Saved on 22.02.2003 09:47
ENGLISH using TecraM1online.dot –– Printed on 24.02.2003 as 1
Wireless LAN
J-3
Tecra M1
■
For wireless clients that operate in a Wireless LAN Infrastructure, the
Wireless LAN card will automatically start operation at the channel
identified by the Wireless LAN Access Point. When roaming between
different access points the station can dynamically switch to another
channel if required.
■
For Wireless LAN cards installed in wireless clients operating in a
peer-to-peer mode, the card will use the default channel 10.
■
In a Wireless LAN Access Point, the Wireless LAN card will use the
factory-set default channel (printed in bold), unless the LAN
Administrator selected a different channel when configuring the
Wireless LAN Access Point device.
Wireless IEEE 802.11 Channels Sets (Revision A)
Frequency Range Channel ID 5150-5850 MHz Note
36 5180
40 5200
44 5220
48 5240
52 5260
56 5280
60 5300
64 5320
149 5745 US only *
153 5765 US only *
157 5785 US only *
161 5805 US only *
* Available Area: US (USA, CANADA) only
A peer-to-peer mode is available under the following condition:
A Wireless LAN card receives a “US county/region code” beacon of the
standard IEEE 802.11 (Revision D) from a Wireless LAN Access Point.
Wireless Channels Sets (Turbo Mode)
Frequency Range Channel ID 5150-5850 MHz Note
42 5210 US only *
50 5250 US only *
58 5290 US only *
152 5760 US only *
160 5800 US only *
* Available Area: US (USA, CANADA) only
A peer-to-peer mode is available under the following condition:
A Wireless LAN card receives a “US county/region code” beacon of the
standard IEEE 802.11 (Revision D) from a Wireless LAN Access Point.