2.2
2.2
2.2
2.2
Installation of the Controller
Installation of the Controller
Installation of the Controller
Installation of the Controller
Install the SOLOgarde controller as follows:
Choose a suitable mounting position for the controller. This should be on the secure side of the door. If the SOLOgarde
controller is to be mounted in the Electrical Surface box or Wall Mounting Box with USB Connector, fit this to the wall.
2.2.1
2.2.1
2.2.1
2.2.1
Surface Mounting
Surface Mounting
Surface Mounting
Surface Mounting
When mounting using self-adhesive feet, choose a suitable flat surface to mount
the controller onto. Fit one foot to each of the three elongated slots in the
underside of the controller board. Peel the liners from the feet and secure the
controller board into the required position. Now route the reader, door and
service cables to the SOLOgarde controller and go to section 2.2.3 for general
installation instructions.
2.2.2
2.2.2
2.2.2
2.2.2
Electrical
Electrical
Electrical
Electrical or Wall Mounting
or Wall Mounting
or Wall Mounting
or Wall Mounting Box Mounting
Box Mounting
Box Mounting
Box Mounting
Route the cable from the reader to the controller. When mounting in an Electrical
Surface Box mounting pass the cables either through the back or side of the box.
When mounting in the Wall Mounting Box with USB Connector pass the cables
through the back or side of the box and connect any reader screen braids to the
earth terminal.
Now go to section 2.2.3 for general installation instructions.
2.2.3
2.2.3
2.2.3
2.2.3
General Installation
General Installation
General Installation
General Installation
Prepare the wiring by stripping approximately 10 mm of insulation from the
conductors. Twist the exposed conductors to ensure that the ends are neat and
that there are no stray strands of wire.
Hint: If more than one wire is to be installed in one terminal, twist the exposed conductors
Hint: If more than one wire is to be installed in one terminal, twist the exposed conductors
Hint: If more than one wire is to be installed in one terminal, twist the exposed conductors
Hint: If more than one wire is to be installed in one terminal, twist the exposed conductors
together to ease insertion of the wires into the terminal.
together to ease insertion of the wires into the terminal.
together to ease insertion of the wires into the terminal.
together to ease insertion of the wires into the terminal.
Make the reader connections as shown in Figure 3 to 14. To make a connection
use a suitable tool (such as a terminal screwdriver) to press down the orange
lever for the appropriate terminal. Ensure that the lever is pressed all the way
down to ensure that the wire guard within the terminal is fully open.
10 mm