21
Marchesan Implementos e Máquinas Agrícolas “TATU” S.A.
RTA-6
Working preparation
• It is important to give finish working in the cut parts.
For this purpose, use a filer. Soon after, remove the filing and
lubricate the "male" with a fine layer of grease.
• Decrease the length of both protective covers using the
cut tubes as a measure and clean the cut residues.
• When using another tractor, verify the length of the cardan
shaft again.
• The chains of the protective covers should be fastened in
the equipment and tractor, so that they will not get loose during
maneuvers.
NOTE
The contact surface between the tube and bar shall not be smaller than 1/3 of
the total length.
• Place the cardan shaft in the power take-off. Note the universal joint forks arrangement
and be careful when disassembling them (see the figure below). The wrong assembly
causes excessive vibration and damage the transmission.
1/3
2/3
Incorrect assembly
Unaligned internal forks
Correct assembly
Aligned internal forks
Summary of Contents for Marchesan RTA 6
Page 1: ...INSTRUCTIONS MANUAL RTA 6...