Part IV–Mixer Controls
TASCAM SX-1
Reference Manual
83
You can adjust any control to change its Initial Status
at any time. In the case of faders, moving the fader
element while in Init Edit will change its Initial Sta-
tus to reflect its new setting. In the case of keys and
knobs, pressing a key while in Initial Edit will
change its Initial Status to reflect its new setting. The
illustration below shows how an Init Edit operation
on a controller set to Auto would look.
Rehearse Functionality
Rehearse
is a special automation setting that
allows you to practice or experiment with mix moves
without actually writing them. It works with all the
Global Modes.
The main advantage of the Rehearse mode is that in
this mode, the SX-1 behaves exactly as if the control
is being written to, but without actually writing data.
For example, when rehearsing a Trim operation you
will hear the results of the Trim and the Revert will
occur just like a real Trim.
Additionally, the rehearsed data will show in the
VGA
Automation
display while being performed, and
then disappear upon transport stop.
8 sec
+12
+6
+3
0
-3
-6
-12
1 sec
2 sec
3 sec
4 sec
5 sec
6 sec
7 sec
Before Initial Status Edit
Initial Status
Dynamic Data
8 sec
+12
+6
+3
0
-3
-6
-12
1 sec
2 sec
3 sec
4 sec
5 sec
6 sec
7 sec
After Initial Status Edit (Increase)
Initial Status
Dynamic Data
8 sec
+12
+6
+3
0
-3
-6
-12
1 sec
2 sec
3 sec
4 sec
5 sec
6 sec
7 sec
-9
After Initial Status Edit (Decrease)
Initial Status
Dynamic Data
Initial Event Ramp Time
