Tandberg Data MSERIES RMC USER, User Manual

Page: 81 / 98

Tandberg Data M-Series Remote Management Card User’s Guide 67
260F Hardware Failure The servo task has received an invalid command code
2610 Hardware Failure The hand action ‘completed’ with no cartridge detected in the hand
2611 Soft Error The put action ‘completed’ with the cartridge still in the hand
2614 Soft Error Command cannot be executed without first initializing the axis
2615 Hardware Failure Theta nvr data has been corrupted, or not yet initialized
2616 Hardware Failure Axis friction nvr data has been corrupted, or not yet initialized
2617 Hardware Failure Axis offset nvr data has been corrupted
2618 Hardware Failure The build nvr data has been corrupted, or not initialized
2619 Hardware Failure An error has been detected in the servo nvr
261B Hardware Failure The hand action ‘completed’ but there was a hand sensor failure
261C Hardware Failure The hand action ‘completed’ but was unable to engage
261D Hardware Failure The hand will not move in either direction
261E Hardware Failure The hand could not get the cartridge to its required position
261F Hardware Failure The elevator sensor of the box was not detected during elevator
calibration
2620 Hardware Failure Elevator nvr data has been corrupted or not yet initialized
2621 Hardware Failure The X axis cannot be moved properly in either direction
2622 Hardware Failure The servo failed to raise the drive hub
2623 Hardware Failure The cartridge is still being retained by the drive
2626 Hardware Failure The Theta angles are out of specification after calibration attempt
2627 Hardware Failure The X axis did not travel the minimum distance when calibrating
2628 Hardware Failure The Y axis did not travel the minimum distance when calibrating
262A Hardware Failure The Theta sensor closest to the right magazine failed to switch
262B Hardware Failure The Theta sensor closest to the left magazine failed to switch
262C Hardware Failure The X axis sensor could not be detected changing state
262D Hardware Failure The Y axis sensor could not be detected changing state
262E Hardware Failure The hand axis did not travel the minimum distance when
calibrating
262F Hardware Failure The X axis friction is too high for normal operation
2630 Hardware Failure The Y axis friction is too high for normal operation
2631 Hardware Failure The Theta axis friction is too high for normal operation
2632 Hardware Failure The hand axis friction is too high for normal operation
2633 Hardware Failure The Z axis did not travel the minimum distance when calibrating
FSC Code
E-mail Message Error
Type Description