Tandberg Data MSERIES RMC USER, User Manual

Page: 33 / 98

Chapter 2 ALERT SNMP
ALERT SNMP Community Management
Tandberg Data M-Series Remote Management Card User’s Guide 19
Table 3 SNMP
Configuration Fields
ALERT SNMP Community Management
2
Communities are used to control access to the ALERT SNMP
operations. The SNMP software must provide valid community
names:
Field Description
Library Name
View or set the library name for the
RMC,
for
example,
MIS library
. If no library name is defined,
the default library name is the
Hostname
of the
RMC
.
Location
Location of the library and
RMC,
for example,
San
Diego office, 101 Main St., Building 15, Room
127
.
Informational
Traps
If selected,
Informational
level traps are enabled. The
Details
button displays a listing of the supported
Informational traps.
Warning Traps
If selected,
Warning
level traps are enabled. The
Details
button displays a listing of the supported Warning
traps.
Failure Traps
If selected,
Failure
level traps are enabled. The
Details
button displays a listing of the supported Failure
traps.
Available
Traps
If selected, a trap is generated every time the library
transitions from an unavailable to an available state.
Unavailable
Traps If selected, a trap is generated every time the library
transitions from an available to an unavailable state.
Trap
Destination
View or set the IP addresses that are to receive the
traps generated by the
RMC
(for example,
123.456.7.89
). Up to five trap destination addresses
may be set. If less than five trap destinations are used,
leave unused
Trap Destination
fields blank.