Tandberg Data MSERIES RMC USER, User Manual

Page: 68 / 98

54 Tandberg Data M-Series Remote Management Card User’s Guide
2413 No mail generated Source slot not present. Magazine or drive removed.
2415 No mail generated Move medium attempted to drive that is being autocleaned
2418 Soft Error Requested action cannot be performed because robot is busy or in
use
2629 Hardware Failure A hand jam has been recovered
2A00 Soft Error Shuttle queue is full
4000 Soft Error SCSI command received for invalid LUN
4001 Soft Error An ASC/ASCQ was used without updating error log logging
4002 Soft Error Illegal SCSI command received
4003 Soft Error Command received, but library is busy
4004 Soft Error Deferred error is pending
4005 Soft Error Unit attention–due to reset
4006 Soft Error Unit attention–due to mode parameters changed
4007 Soft Error Unit attention–due to medium changed
4008 Soft Error SCSI command had invalid field in CDB
4009 Soft Error SCSI command had parameter list length error
400A Soft Error SCSI command had invalid field in parameter list
400B Soft Error SCSI command had invalid parameter value
400C Soft Error SCSI command failed due to servo problem
400D Soft Error No sense available
400E Soft Error Cleaner cartridge fitted
400F No mail generated Move medium destination full
4010 No mail generated Move medium source empty
4011 Soft Error Parameters not saved. Undefined.
4012 Soft Error Illegal element number
4013 Soft Error Cannot complete command while cartridge is in hand
4014 Soft Error Power-on configuration not yet finished
4015 Soft Error Library will be ready soon, check back later
4016 Soft Error Not ready–unknown reason
4017 Operator Access Door is open
4018 Operator Access Import/export is open
4019 Configuration Change Operator panel is in menu mode
401A Operator Access Import/export has been accessed
FSC Code
E-mail Message Error
Type Description