28
W301-0411E
Chapter B
Chapter B
User Mode
B-2 Registration of Operating State and AML Function Check
WARNING
Before you start the crane operation, make sure that correct operation state is registered
and the AML system functions normally. If you register the operation state incorrectly or the
AML system does not operate normally, the machine can overturn or suffer damage, and
this can cause a fatal injury.
Before the crane operation, observe the steps below to register the operation state and be sure to do the AML
function check.
1. Set the PTO switch to "ON".
•
The PTO indicator lights up, and the power is
supplied to the AML.
2. Set up the outriggers.
2.1 Registration of Outrigger State
3. Push the <
> key (outrigger state select).
•
The pop-up window for the outrigger state
registration is shown on the display panel.
Each time the <
> key (outrigger state select) is
pushed, the display changes as shown below..
When the power for the AML is turned on, the "On-rubber (creep) operation" state is automatically set.
Instead of the outrigger state select key, you can use the < > key (backward) or < > key (forward)to
change the display of the outrigger state.
