Synxcom SM9234D, User Manual

Page: 81 / 216

AT Commands
Page 81
If the local handset is picked up while the modem is off-hook, the modem will do a
link-disconnect, flash the hook for 1.5 seconds, then connect the local handset to
the line. At this point, the user dial tone should be on the local handset. The
disconnect reason in S86=25.
Behavior in Voice Mode (+FCLASS=8)
When in voice mode and an extension is picked-up, a <DLE>P is sent to the DTE.
When the modem is off-hook , a line reversal may also be detected in which case a
<DLE>l is sent to the DTE.
In voice mode, there is no blocking of ATDT when the line is in use. Also, there is
no automatic hang-up in voice mode as in data mode. There is only the above
stated <DLE> shielding event reporting.
Operation in Data Mode
Line-In-Use (Enabled by AT-STE=1, AT-STE=3, AT-STE=5, or AT-STE=7)
Case 1: Telephone Line is in Use
If an ATDT, ATDP, or ATDL is issued while Line-In-Use detection is enabled
and the telephone line is in use, the modem will immediately return the message
LINE-IN-USE to the DTE without going off-hook, and then return to command
mode.
Case 2: Telephone Line is in Use But Disconnected
If an ATDT, ATDP, or ATDL is issued while Line-In-Use detection is enabled
and the telephone line is NOT in use, the modem will go off-hook after a short
pause, then respond with CONNECT or NO CARRIER message.
Case 3: Telephone Line is Not Connected to Modem
If an ATDT, ATDP, or ATDL is issued while Line-In-Use detection is enabled
and the telephone line is not connected, the modem will go off-hook momentarily,
go back on-hook, then respond with NO DIAL TONE message.
Extension Pick-up (Enabled by AT-STE=2, AT-STE=3, AT-STE=6, or AT-STE=7):
Case 1: Modem off-hook, Local Handset Goes Off-Hook
If the local handset goes off-hook while the modem is in a data connection, the
local handset will be muted. The modem will then send a GSTN Cleardown to the
remote modem and then go on-hook. The modem will then send a NO