Synxcom SM9234D, User Manual

Page: 79 / 216

AT Commands
Page 79
*B - Display Blacklisted Numbers
This command requests the modem to return a list of blacklisted numbers to the
DTE. The format of the response is shown by the example below. Permanently
forbidden numbers as defined by country requirements will not appear on this list.
If no numbers are blacklisted, only the OK result code is issued.
Syntax *B
Example
NO. - PHONE NUMBER -------
------------------------------
1; 4175537660
2; 8288924961
3; 3887278862
4; 3124839442
5; 6284664
OK
*D - Display Delayed Numbers
This command causes the modem to send a list of the delayed numbers together
with the delay associated with each. The modem will return a list of delayed
telephone numbers as defined in the *B command. The format of the response is
shown by the example below (delay times are shown as hours:minutes:seconds). If
no numbers are delayed, only the OK result code is issued.
Syntax
*D
Example
NO. - PHONE NUMBER -DELAY
------ -------------------------------------------
1; 8264734660 2:00:00
2; 7532634661 2:00:00
3; 2587334662 0:02:00
4; 7532651663 0:03:25
5; 7459931664 0:01:45
OK
–PPD= - Extension Pickup Notification through 16550 UART
The –PPD=1 command allows setting of the DDSR (bit 1 of register 6) when an
extension pick-up is detected, and disables all DSR notification. The –PPD=0
command disables this feature.
This feature is available only on a SmartSCM that is configured for parallel
operation.
–STE= - Set Telephony Extension