Synxcom SM9234D, User Manual

Page: 190 / 216

AT Commands
Page 190
+FCQ - Copy Quality Checking
Write syntax: +FCQ=<value>
Valid values: 0
Default value: 0
This parameter controls Copy Quality checking by a receiving facsimile DCE. The
DCE returns +FCQ=0 which indicates the DCE does no quality checking. The
DCE will generate Copy Quality OK (MCF) responses to complete pages, and set
+FPTS=1.
+FPHCTO - DTE Phase C Response Time-out
Write syntax: +FPHCTO=<value>
Valid values: 0 - 255, 100 millisecond units.
Default value: 30
The +FPHCTO command determines how long the DCE will wait for a command
after reaching the end of data when transmitting in Phase C. When this time-out is
reached, the DCE assumes there are no more pages and no documents to send. It
then sends the T.30 EOP response to the remote device.
+FAXERR - T.30 Session Error Report
Read syntax: +FAXERR= <table value>, read only
Valid values: 0 - 255, see Table A-26 for meaning
This read-only parameter indicates the cause of the hangup. Table A-26 shows the
valid values for this parameter as well as the meaning of the each value.
+FAXERR is set by the DCE at the conclusion of a fax session. The DCE resets
+FAXERR to 0 at the beginning of Phase A off-hook time.
+FBOR - Data Bit Order
Write syntax: +FBOR=<value>
Valid values: 0, 1, 2, or 3
Default value: 0
This parameter controls the mapping between PSTN facsimile data and the DTE-
DCE link. There are two choices:
Direct: The first bit transferred to each byte on the DTE-DCE link is the first bit
transferred on the PSTN data carrier.
Reversed: The last bit transferred of each byte on the DTE-DCE link is the first bit
transferred on the PSTN data carrier.