Synxcom SM9234D, User Manual

Page: 106 / 216

AT Commands
Page 106
+ITF?
+ITF: (0-255),( 0-255),(0)
The maximum reported <off> value is the input transmit data buffer level at which the
modem signals a transmit data overrun indication to the DTE.
Diagnostic Commands
#UD – Last Call Status Report
#UD is an action command requesting reporting of logged operation events. It
does not take parameters and must be the last command in the command line.
The modem logs aspects of their operation for each call, and saves these results
until cleared by one of the following events:
1. Power off.
2. Hard reset (e.g., negate DTR with &D3 set; reset button).
3. Soft reset = ATZ or AT&F.
4. ATD command issued.
5. ATA command issued.
6. Automatic answer (e.g., set register S0>0 and ring detected).
7. These results are NOT cleared by changing DTR, V.24 circuit 108.2, if
&D0, &D1 or &D2.
Data Call State Model
For purposes of this command, there are four data call states, and associated status
issues:
•
Call Setup
Calling DCE: get dial tone, generate dial digits, detect call progress
signals.
Answering DCE: detect ringing, detect CallerID, etc.
•
Negotiation
V.25 calling tone/answer tone exchanges
V.8 or V.8bis call function negotiations
V-series modem carrier detection and training
Modem-to-modem protocols (e.g., V.42, V.42bis).