Synectix VMS Lite, User Manual

Page: 28 / 83

Synectix VMS Lite
27
Synectix VMS Lite
announces the current dialing mode by numbers. Enter new value in
numbers to indicate tone, pulse or long tone dialing mode. Default value is 1 (Tone).
1.5.1.5 Message Waiting Lamp Parameters:
The Message Waiting Lamp (MWL) is normally available on most digital phone
instruments and some analog phones. This lamp may be made to glow on or off by
sending an appropriate string to the PBX and is usually made to flash when a mailbox-
owner gets a new message.
Synectix VMS Lite
first announces the current status (enabled/disabled) for the MWL
followed by the prompt:

Press 1 to Enable Message Waiting Lamp

Press 2 to Disable Message Waiting Lamp

Press 3 to Enter Enable String

Press 4 to Enter Disable string
The ‘Enable String’ and ‘Disable String’ may contain maximum 16 characters. If the
strings are not 16 characters long, you may press ‘#’ to terminate the entry and go to
the next prompt. After entering the strings, press 1 to accept or cancel and return to
previous menu by pressing 9.
Example: If the ‘Enable String’ is ‘*761E’, you have to enter ‘**761*3’.
1.5.1.6 In-band Strings:
Some PBX systems signal the status of a call that was transferred to an extension by
sending a string called “In-band signaling strings”. In such cases, it is necessary to have
a special method for entering non-digit values as described earlier.
Maximum number of characters allowed = 16
Press the # key if the total number of digits entered is less than the maximum allowed.
After you press 6 for In-band Strings, you will hear the following prompt:

Press 1 for Wait Time for 1st Digit.

Press 2 for Wait Time between Digits.

Press 3 for Mailbox Login String.

Press 4 for Busy String.

Press 5 for Alternative Busy String.

Press 6 for No-Answer String.

Press 7 For Alternate No-answer String.

Press 8 for Other Strings (Hang up string and Invalid string)
Wait Time For 1st Digit: This is the maximum time up to which the Synectix VMS Lite
waits after going off hook to receive the in-band strings. Enter new value in two-digit
format. The wait time value ranges from 00 to 99 where the actual wait time is equal to
the entered value multiplied by 50 milliseconds. The Default value = 0