Synectix VMS Lite, User Manual

Page: 19 / 83

Synectix VMS Lite
18
In this field, you are allowed to enter a total of 11 characters. This character-set may
consist of digits and ‘*’. The first character of the pager display string cannot be ‘*’. If
your pager display string does not contain 11 characters, (say, it is 7 character-long),
press # to terminate your entry.
Note : You must check with your Paging Service Provider if any specific string
restrictions are applicable (e.g. numeric only etc.)
1.3.2.2 No. Of Retries
This is the number of times the
Synectix VMS Lite
tries to externally notify a New
Message. Valid digits are 0 to 6. (If 0 is programmed, the unit will not retry at all).
1.3.2.3 Trunk Access Key
Trunk Access Key is also known as the ‘Out Dial Digit’. This is the digit (or digits) to be
dialed before dialing an external number. It may be a single digit or 2 digits. This
information must be entered before attempting an External Notification.
1.3.2.4 Answer Detection Time
This is the amount of time for which the Synectix VMS Lite will wait to detect a voice
frame to decide that the call has been answered.
You may enter any value between 01 and 29. (This value must be entered in two-digit
format). The actual Answer Detection time is equal to the entered value multiplied by
33 milliseconds. The Unit does not accept any value outside the range of 1 to 29.
Note:
The Answer Detection time must be carefully set for each installation keeping in
mind the type of lines and services available at that location.
1.3.2.5 Time Before No-Answer
It varies from 1 to 19 (both inclusive). You have to enter this value in two-digit format.
The value chosen by you is multiplied by 3 Seconds by the Unit. The Unit does not
accept any value that is outside the range of 1 to 19.
1.3.3 Extension Options
‘Extension Options’ includes single digit plan, creation and deletion of various kinds of
extensions (Invalid Extensions, operator extensions, fax extensions etc.),
enabling/disabling ‘Extension prompting while transferring’ feature. All these are
Extensions without Mailboxes.
After you press 3 to select ‘Extension Options’, you have the following options:

Press 1 to Edit Invalid Extensions (1.3.3.1)

Press 2 For Operator Features (1.3.3.2)

Press 3 For Fax Extensions (1.3.3.3)

Press 4 For Single Digit Plan (1.3.3.4)

Press 5 For Extension Prompting While Transferring (1.3.3.5)