Step 4, To install the room unit (thermostat)
The room unit contains a temperature sensor used for measuring the current
room temperature. In order for the controller to regulate the temperature in
relation to the preset setting, the room unit must be installed in such a way
that enables it to correctly measure the temperature. The room unit should,
for example, not be exposed to direct sunlight.
1
3
2
Figure 7. To mount the room unit (thermostat).
Pos 1. Front piece.
Pos 2. Back piece.
Pos 3. Screws suitable for the supporting surface.
1. Select a suitable location in the room for installing the room unit. The
recommended height above the floor is standard height for of a light
switch.
2. Remove the back piece from the room unit.
N.B.!
Tighten the back piece only in the right-hand and the left-hand
fastening holes.
3. Then secure the back piece to the wall by means of two countersink
screws, appropriate for the supporting surface.
35
20210201 Swegon reserves the right to make design changes.
CONDUCTOR
W4
Summary of Contents for 20210201
