Swegon 20210201, Technical Manual

Page: 52 / 72

Change parameters
General param.
<Exit Select>
Appl. Param.
Alarms
......................
Parameter
<Exit
System 1=H, 2=C, 3=ChOv, 4=HC
Min 1 Max 4
Value
4 -
Change>
P_1901
Figure 22. Image for selecting changes in the application parameters and typical parameter
image.
1. Go to the Service menu.
2. Depending on which parameters you want to change, highlight the
appropriate General parameter or Application parameter.
3. Press OK or on the
►
Right key.
4. Enter the authorization code for General parameters or Application
parameters.
5. Select the parameter to be altered by pressing the
▲
UP or
▼
DOWN
key.
6. Highlight the value by pressing the
►
Right key.
7. Change the value by pressing the
▲
UP or
▼
DOWN key.
8. Press OK to confirm the new value.
9. Press the
◄
Left key to exit the parameter change image.
10. Highlight:
• Yes to save the changes you’ve made.
• No to not to save the changes.
• Cancel to return to parameter change image.
11. Press OK to return to the Service menu.
Show system information
Settings
<Exit Select>
System info
General Param.
......................
Room temp 22,8C
RE’s rf ID 181
Battery Level 5,1V
<Exit
Figure 21. Image for selecting Info and
the first image in System information.
1. Go to the Service menu.
2. Highlight Info.
3. Press OK or on the
►
Right key.
Current information for the application is shown in the System
information images. Navigate between the images by pressing the
▲
UP
or
▼
DOWN key.
4. Return to the Service menu by pressing the
◄
Left key.
Application
SW ver. RE
SW ver. RU
<Avsluta
W4
1.48
1.8
CONDUCTOR W4
52
Swegon reserves the right to make design changes.. 20210201