Svantek SV 200A, User Manual

Page: 121 / 198

121 SV 200A User Manual
12 MAINTENANCE
12.1 T
RANSPORTATION AND STORAGE
For transportation or storage purpose, we recommend using the packaging provided by the
manufacturer.
12.2 C
LEANING
Clean the surface of the instrument with damp soft cloth.
Note: Do not allow the water ingress into the bottom panel. It can damage SV 200A!
The instrument sockets should be cleaned with the use of compressed air.
Note: In cases of larger dirt, such as oil or grease, contact your Local Authorized Distributor
or Svantek Service Office.
12.3 R
ESETTING THE INSTRUMENT
•
SYSTEM RESET: internal software reset clears any setup configuration and brings back the
default Factory Settings (see Chapter 5.1.2 ).
•
HARDWARE RESET: internal hardware reset, no user data is changed. Make sure the battery
is not exhausted, and the unit is turned off. Press and hold the key for more than 10
seconds, and then release it. Turn on the instrument as usually by pressing the key
for more than 3 seconds (see Chapter 3.2 ).
Note: Hardware reset is only to be used in extreme situations such as an instrument
hang-up.
Be aware, that a hardware reset:
- will stop any pre-programmed auto-run modes,
- will stop measurement run!
12.4 T
ROUBLESHOOTING
•
In the case your instrument does not respond proceed with hardware reset of the instrument (see
Chapter
12.3 ).
•
In the case the reset does not help call your Local Authorized Distributor or Svantek Service
Office.
Should your SVANTEK professional measurement equipment need to be returned for repair or for
calibration, please contact the service office at the following number or contact via the SVANTEK’s
website.