2-3
Chapter 2: Installation
4. Slid the clip (A) onto each support toward the processor, expos-
ing the hole that will fit over the peg on the motherboard. Push the
latches (B) on the processor toward the center of the processor
until they click into place.
5. Hold the processor so that the fan shroud is facing toward the
pegs on the motherboard. Slide the processor (C) into the reten-
tion mechanism and slide the supports onto the pegs. Ensure that
the pegs on the motherboard slide into the holes in the heat sink
support and that the alignment notch in the SEC cartridge fits over
the plug in Slot 1. Push the processor down firmly, with even pres-
sure on both sides of the top, until it is seated.
Figure 2-3. Retention Mechanism
B
C
A
Do not screw in too tight!
Summary of Contents for SUPER P6DGH
Page 1: ...SUPER P6DGH USER S AND BIOS MANUAL Revision 1 0 SUPER...
Page 14: ...1 4 SUPER P6DGH User s Manual SUPER P6DGH Figure 1 1 SUPER P6DGH Motherboard Image...
Page 33: ...2 6 SUPER P6DGH User s Manual Figure 2 6 Installing a Slot 1 Processor...