Assembly Instructions for:
31600 Motor Carrier
PO Box 8, 644 2
nd
Street
St. Paul Park, MN 55071
Form 12.121
Phone: (651) 459-9795
E-mail:
On the Web:
www.garelick.com
Revision Date: 08/07
TOOLS Required:
Page 1
Hammer
CAUTION: Tubing will crush if over-tightened.
Step 1
:
Motor Carrier Assembly
A.
Slide bottom braces on axle using large holes as
shown.
B.
Slide Upright support tube on axle using large holes
as shown.
Step 2
:
A.
Place plastic washer on axle.
B.
Place wheel on axle as shown.
C.
Secure with pin. **Bend pin to secure in place**
D.
Place caps on wheels. Gently tap into place with
hammer.
Step 3
:
Place tank tie straps on upright supports as shown.
Step 4
:
Attach plastic block to each end of upright support by
aligning holes. Insert 4 bolts (2 7/8” long) and tighten
fasteners.
NOTE: Top of block should be even with ends of
upright tubes as shown.
Plastic Washer
Bend pin
Cap
Upright Support Tube
Bottom Brace
Axle
