Supero SUPER P6DGH, User Manual

Page: 95 / 113

Chapter 5: Running Setup
5-21
Parallel Port DMA Channel
This option is only available if the setting of the parallel port mode option
is ECP. The settings are 0, 1, 2, 3, 5, 6 or 7. Note: The option is N/A.
Onboard IDE
This option specifies the onboard IDE controller channels to be used. The
settings are Disabled, Primary, Secondary or Both.
5-2 Security Setup
Supervisor/User
The system can be configured so that all users must enter a password
every time the system boots or whenever the W INBIOS setup is ex-
ecuted. You can set either a Supervisor password or a User password.
If you do not want to use a password, just press <Enter> when the
password prompt appears.
The password check option is enabled in the Advanced Setup by
choosing either Always or Setup. The password is stored in CMOS RAM.
You can enter a password by typing the password on the keyboard or
by selecting each letter via the mouse or a pen stylus. Pen access must
be customized for each specific hardware platform.
When you select Supervisor or User, AMIBIOS prompts for a password.
You must set the Supervisor password before you can set the User
password. Enter a 1-6 character password. The password does not
appear on the screen when typed. Retype the new password as
prompted and press <Enter>. Make sure you write it down. If you forget
it, you must clear CMOS RAM and reconfigure.