3-2
SUPER P6DGH User's
Manual
No Power
1.
Make sure the default jumper is on and the CPU is correctly
setup.
2.
Turn the power switch on and off to test the system.
3.
If the power is still not on, turn off the system power and
move jumper JP20 from 2-3 to 1-2.
4.
If moving the jumper setting has not helped, clear CMOS.
5.
Check the power supply voltage monitor. (Check the power
supply 115V/230V switch)
No Video
Use the following steps for troubleshooting your system configu-
ration.
1.
If the power is on but you have no video, remove all the add-
on cards and cables.
2.
Check for shorted connections, especially under the
motherboard.
3.
Check the jumpers settings, clock speed and voltage settings.
4.
Use the speaker to determine if any beep codes exist. Refer
to Appendix A for details about beep codes.
NOTE
If you are a system integrator, VAR or OEM, a POST
diagnostics card is recommended. For port 80h codes,
refer to Appendix B.
Memory Errors
If you encounter a memory error, follow the procedures below.
1.
Check to determine if the DIMM modules are improperly
installed.
2.
Make sure that different types of DIMMs have not been in-
stalled in different banks.
3.
Determine if different speeds of DIMMs have been installed
and verify that the BIOS setup is configured for the fastest
speed of RAM used. It is recommended to use the same
RAM speed for all DIMMs in the system.
Summary of Contents for SUPER P6DGH
Page 1: ...SUPER P6DGH USER S AND BIOS MANUAL Revision 1 0 SUPER...
Page 14: ...1 4 SUPER P6DGH User s Manual SUPER P6DGH Figure 1 1 SUPER P6DGH Motherboard Image...
Page 33: ...2 6 SUPER P6DGH User s Manual Figure 2 6 Installing a Slot 1 Processor...
