32
Sun Server X3-2 Installation Guide • April 2014
▼
Install the Server Into the Slide-Rail
Assemblies
Use this procedure to install the server chassis, with mounting brackets, into the
slide-rail assemblies that are mounted to the rack.
Caution –
This procedure requires a minimum of two people because of the weight
of the server. Attempting this procedure alone could result in equipment damage or
personal injury.
Caution –
Always load equipment into a rack from the bottom up so that the rack
will not become top-heavy and tip over. Extend your rack’s anti-tilt bar to prevent
the rack from tipping during equipment installation.
1. Push the slide-rails as far as possible into the slide-rail assemblies in the rack.
2. Position the server so that the rear ends of the mounting brackets are aligned
with the slide-rail assemblies that are mounted in the rack.
3. Insert the mounting brackets into the slide-rails, and then push the server into
the rack until the mounting brackets encounter the slide-rail stops
(approximately 30 cm, or 12 inches).
Summary of Contents for X3-2
