Sun Oracle X3-2, Installation Manual, Page: 73 / 182

Cabling the Server 61
■
For a remote Ethernet connection – Connect an Ethernet cable between the
server’s network management port (NET MGT) and the network to which
future connections to the SP and host will be made.
If using Oracle ILOM, configure the system for the first time through the SER
MGT port. After initial configuration, you can set up communication between
the SP and host through the remote Ethernet interface.
3. For network access, connect an Ethernet cable between the server’s NET ports
(NET3-0) and the network to which the server will communicate.
▼
Connect the Power Cords
1. For each installed power supply, connect one grounded server power cord to a
grounded electrical outlet.
2. Connect the server power cords to the power supply AC connectors on the back
panel of the server and use the Velcro strap to secure them.
When the power cords are connected to the system, the power supply LEDs light
and the SP OK LED will blink rapidly while the service processor (SP) is booting.
The SP OK LED will be illuminated solid green once the service processor has
successfully booted. After the service processor has booted, the Power/OK LED
on the front panel will blink slowly, indicating the host is in standby power mode.
In standby power mode, the server is not yet initialized or powered on.