Preparing for Server Installation
19
Caution –
To protect electronic components from electrostatic damage, which can
permanently disable the system or require repair by service technicians, place
components on an antistatic surface, such as an antistatic discharge mat, an antistatic
bag, or a disposable antistatic mat. Wear an antistatic grounding strap connected to a
metal surface on the chassis when you work on system components.
Caution –
Deploy the anti-tilt bar or legs on the equipment rack before beginning an
installation.
Caution –
The server weighs approximately 18.1 kg (39.9 pounds). Two people are
required to lift and mount this 1 rack unit (1U) server into a rack enclosure when
using the procedures in this document.
Caution –
When completing a two-person procedure, always communicate your
intentions clearly before, during, and after each step to minimize confusion.
Related Information
■
“Safety Precautions When Rackmounting the Server” on page 23
Optional Component Installation
Standard system components are installed at the factory. Optional components that
you purchased independent of the standard configuration are shipped separately,
and in most cases should be installed before you install the server in a rack.
The following optional components can be ordered and purchased separately:
■
PCIe cards
■
DDR3 DIMM memory kits
Summary of Contents for X3-2
