Sun Microsystems Ultra 5, Service Manual

Page: 99 / 258

Chapter 4 Troubleshooting Procedures 4-27
SUBTEST=’bmac_tx_reg_test’
SUBTEST=’mif_reg_test’
SUBTEST=’mac_internal_loopback_test’
SUBTEST=’10mb_xcvr_loopback_test’
SUBTEST=’100mb_phy_loopback_test’
SUBTEST=’100mb_twister_loopback_test’
TEST=’keyboard_test’
SUBTEST=’internal_loopback’
TEST=’mouse_test’
SUBTEST=’mouse_loopback’
###OBDIAG_MFG_START###
TEST=’mouse_test’
STATUS=’FAILED’
SUBTEST=’mouse_loopback’
ERRORS=’1 ‘
TTF=’1011 ‘
SPEED=’299.80 MHz’
PASSES=’1 ‘
MESSAGE=’Error: Timeout receiving a character’
TEST=’floppy_test’
SUBTEST=’floppy_id0_read_test’
TEST=’parallel_port_test’
SUBTEST=’dma_read’
TEST=’uarta_test’
‘UART A in use as console - Test not run.’
TEST=’uartb_test’
BAUDRATE=’1200’
SUBTEST=’internal_loopback’
BAUDRATE=’1800’
SUBTEST=’internal_loopback’
BAUDRATE=’2400’
SUBTEST=’internal_loopback’
BAUDRATE=’4800’
SUBTEST=’internal_loopback’
BAUDRATE=’9600’
SUBTEST=’internal_loopback’
BAUDRATE=’19200’
SUBTEST=’internal_loopback’
BAUDRATE=’38400’
CODE EXAMPLE 4-22
All Above Output Message (Continued)