Sun Microsystems Ultra 5, Service Manual

Page: 160 / 258

8-14 Sun Ultra 5 Service Manual • February 2000
FIGURE 8-6
Removing and Replacing the PCI Riser Board
8.5.2 Replacing the PCI Riser Board
1. Replace the PCI riser board as follows (
FIGURE 8-6
):
a. Position the PCI riser board into the chassis.
b. Position the PCI riser board connector so that it touches its associated connector
on the motherboard.
c. At the two upper corners of the PCI riser board, push the board straight
downward into the connector until the card is fully seated.
d. Using a No. 2 Phillips screwdriver, replace the two screws securing the PCI
riser board to the system chassis.
2. Replace the PCI card(s) into the PCI riser board.
See Section 8.4.2 “Replacing a PCI Card” on page 8-11.
3. Detach the wrist strap, replace the system cover, and power on the system as
decribed in Chapter 10.
Screw (2)
PCI riser board