Sun Microsystems Ultra 5, Service Manual

Page: 135 / 258

Chapter 7 Storage Devices 7-7
7.2.2 Replacing a Primary Hard Drive
Note –
Read the hard drive product guide for information about jumpers, switch
settings, or other installation tasks.
Note – Prior to replacing a hard drive, verify that the drive’s back panel mode-
select jumper is set to CS.
1. Replace the primary hard drive as follows (
FIGURE 7-3
and
FIGURE 7-4
):
a. Position the hard drive into the hard drive bracket.
b. Using a No. 2 Phillips screwdriver, replace the four screws securing the hard
drive to the hard drive bracket.
c. Position the hard drive and hard drive bracket into the chassis, ensuring that
the bracket engages the two alignment tabs on the chassis bottom.
d. Using a No. 2 Phillips screwdriver, replace the two screws securing the hard
drive bracket to the chassis.
e. Connect the hard drive cable connector and the power cable connector to the
hard drive. Dress cables.
Note – Verify that the cable connectors are oriented properly by aligning the
connector keys.
f. Connect the power cable connector and the CD-ROM drive cable connector to
the rear of the CD-ROM drive. Dress cables.
Note – Verify that the cable connectors are oriented properly by aligning the
connector keys.
2. Detach the wrist strap, replace the system cover, and power on the system as
decribed in Chapter 10.