Sun Microsystems Ultra 5, Service Manual

Page: 137 / 258

Chapter 7 Storage Devices 7-9
Note – Verify that the cable connectors are oriented properly by aligning the
connector keys.
The following diagram shows the cabling for the hard drives when two hard drives
are installed.
FIGURE 7-5
Hard Drive Cabling Configuration with Two Hard Drives
13. Place the three holes on the new hard drive bracket over the three securing screws
on the chassis.
14. Carefully slide the hard drive bracket forward until it stops.
15. Tighten the three screws that secure the drive bracket to the chassis.
16. Dress cables to provide clearance.
17. Reinstall any PCI card you removed from PCI slot 2.
See Section 8.4.2 “Replacing a PCI Card” on page 8-11.
18. Detach the wrist strap, replace the system cover, and power on the system as
decribed in Chapter 10.
Hard drive cable
Secondary hard drive Motherboard J15
(primary channel)
Primary hard drive
(master-device 0)
(slave-device 1)