Sun Microsystems StorEdge 6920 System, Getting Started Manual

Page: 98 / 144

80 Sun StorEdge 6920 System Getting Started Guide • May 2004
TABLE B-1
lists the field-replaceable units (FRUs) required to perform the tasks in this
appendix.
The following tools are required to perform the tasks in this appendix:
■
Keys for key switch (in the kit shipped with the system)
■
Phillips screwdriver
Preparing the System for Remote Power
The information in this section assumes you are installing the Sun StorEdge 6920
system for the first time and have not yet powered on the system.
Note – If you want to enable remote power management for a system that is
operational, you must first perform a full system shutdown, as described in
“Performing a Full System Shutdown” on page 93. After shutting down the system,
you can enable the system for remote power management by completing the
following steps.
1. Verify that the key switches located at the bottom front of the base cabinet and
any expansion cabinet are in the Standby position (
FIGURE B-1
).
Keys for this switch are packed in the kit that was shipped with the base cabinet and
expansion cabinet (if applicable). If the key switch is not in the Standby position,
insert the key and turn the key switch to Standby.
TABLE B-1
Power Cable—FRU List
Quantity FRU Description Part Number
2 Power cable for 72-in. (185-centimeter) Sun StorEdge
cabinet (U.S./Canada), L6-30P 595-4881-nn
2 Power cable for 72 in. (185 cm) Sun StorEdge expansion
cabinet (International), IEC 309 595-4882-nn
1 78.74 in. (2-meter) grounding cable (in the kit shipped with
the system) 530-1619-nn
2 393.7 in. (10-meter) expansion cabinet DB9 to base cabinet
DB9 cable (if needed) 530-3210-nn