Sun Microsystems StorEdge 6920 System, Getting Started Manual

Page: 13 / 144

Preface xiii
Preface
The Sun StorEdge™ 6920 System Getting Started Guide provides procedures for
installing the Sun StorEdge™ 6920 system. This guide describes how to complete
the initial setup of the system, power the system on and off, and connect the
system to the data hosts on the storage area network (SAN) and the management
console on the local area network (LAN).
Before You Read This Book
Before you begin to install the Sun StorEdge 6920 system, you must prepare the
installation site as described in these books:
■
Sun StorEdge 6920 Regulatory and Safety Compliance Manual
■
Sun StorEdge 6920 System Site Preparation Guide
How This Book Is Organized
Chapter 1 contains an introduction to the Sun StorEdge 6920 system.
Chapter 2 describes pre-installation planning, safety, and installation of the system
cabinet, and system startup.
Chapter 3 describes the steps you must take to establish an initial connection to the
system, run the setup utility, log in to the system, navigate the system, and use the
wizards to configure storage on the system.