Sun Microsystems StorEdge 6920 System, Getting Started Manual

Page: 59 / 144

Chapter 3 Configuring the System 41
6. Specify a unique host name for the new system by typing a number from 0
through 7.
If this is the first system at the site, type
0
. There can be a maximum of eight systems
in one configuration (
sp0
through
sp7)
. If more than one Sun StorEdge 6920 system
is installed at your site, use the next highest number in sequence for each installed
system.
7. At the prompts, provide information about your network configuration.
Type
1
to configure dynamic host control protocol (DHCP) IP addressing, or
2
to
configure a fixed or static IP address for the system. Sun recommends using fixed IP
addressing. If you choose DHCP, binding must be persistent and not dynamic.
8. Specify the remaining network configuration information at each prompt.
Please enter the StorEdge 6920 Id.
A valid value is a digit between 0 and 7.
Your Choice: 0
Network Settings:
--------------------
Do you wish to use DHCP or Fixed Network Addresses?
1. DHCP
2. Fixed
Your Choice: 2
Please enter the IP Address for the StorEdge 6920:
XX.X.XX.X
Please enter the Gateway Address for the StorEdge 6920:
XX.X.XX.X
Please enter the Network Mask for the StorEdge 6920:
XXX.XXX.XXX.X
Please enter the Nameserver IP Address for the StorEdge 6920:
XX.X.X.X
Please enter the Nameserver Domain for the StorEdge 6920:
yourserver
.com