Sun Microsystems StorEdge 6920 System, Getting Started Manual

Page: 73 / 144

Chapter 3 Configuring the System 55
5. To set up remote notification:
a. Click Administration > Notification > Remote Notification.
The system displays the Remote Notification page.
b. From the Select Provider menu, select the services you want to activate.
The Sun StorEdge 6920 system supports the following providers:
■
NSCC – Sends notifications by email to the Sun Network Storage Command
Center (NSCC), which enables Sun to continually improve the product and its
support through analysis of this data.
■
SAE – Sends notifications to the Sun StorEdge Automated Diagnostic Expert
(SAE).
■
SSRR – Sends notifications to the Sun StorEdge Remote Response service.
■
SNMP – Sends SNMP traps to external management systems for all actionable
events that occur during monitoring.
c. Select the Active check box.
d. Click Update.
6. To log out of the system, click Log Out.
To activate Do this
NSCC Select Encrypt Email if you want to encrypt remote email.
SAE Type the IP address of the Sun StorEdge Automated Diagnostic Expert
management console.
In the Heartbeat Frequency field, type the frequency (in minutes) with
which you want to check the communication link to the SAE provider.
SSRR Type the frequency (in hours) with which you want to check the
communication link to the SSRR provider. Typical values are 6, 12, and
24 hours.
SNMP Select the SNMP version from the SNMP Version list.
Type the IP name and address that identifies the host to the network.
You can provide information for up to five IP addresses.
Specify the minimum alert level: Major, Critical, Down, or Notice.