Sun Microsystems Netra t1 100, User And Administration Manual

Page: 118 / 154

96 Netra t1 User and Administration Guide • June 2000
Cannot Set up a Console Connection to the Netra t1
The Netra t1’s serial port pinouts are listed in Chapter 6. Check that they are correct
for the device (that is, the terminal or terminal server) that you are connecting to the
Netra t1.
Cannot Boot from the Internal CD-ROM drive
If you do not have patch 108673-04 applied and you have Solaris installed, then
apply the patch and try booting again from the CD-ROM drive.
If you do not have patch 108673-04 applied but you have no operating system
installed, do the following:
1. At the ok prompt, type:
2. Next, type:
3. If you had the
auto-boot?
environment variable set to
true
originally, return it
to
true
by typing:
4. When the system has finished performing the reset, wait for 30 seconds, then try
booting again from the CD-ROM drive.
5. If this was not successful, check that the CD-ROM drive and cables are properly
seated (see Chapter 4).
Cannot Plug the Network Cable into a Port on a PCI Card
Make sure that the PCI card is seated horizontally in its connector. It must not sit at
an angle (see Chapter 4).
ok setenv auto-boot? false
ok reset-all
ok setenv auto-boot? true
SysAdmin.book Page 96 Friday, March 30, 2001 2:38 PM