Sun Microsystems Netra t1 100, User And Administration Manual

Page: 83 / 154

Chapter 7 Powering Up the Netra t1 61
You must replace the letter
b
( after
term/
and before the third colon) with the letter
a
, so that the line looks as follows:
▼
To Power the System Up for the First Time
Before following the instructions in this section, read them to find out what
information the system prompts you for when you start it for the first time.
With the system connected to the power supply but not powered up, and with a
serial connection to the Serial A/LOM port and a connection to at least one Ethernet
hub (as described in Chapter 6), follow the instructions below:
1. At the
lom>
prompt which automatically appears in your Terminal screen, type
the following command to power on the system:
For more information about the
lom>
prompt and the commands that are available
from it, see Chapter 9.
2. During booting you will be prompted for certain information.
The first question the system asks you is what language you want it to use when it
prompts you for the information it needs. Specify a language.
3. Next specify your locale.
4. Specify the type of terminal you are using to communicate with the Netra t1.
5. Specify a Host Name for the system.
6. When asked if you are connected to the network by a Solaris-supported Ethernet
card, answer Yes.
7. Specify which of the Ethernet ports you intend to use as the primary Ethernet
connection.
For the port labeled Net0, specify
hme0
. For the port labeled Net1, specify
hme1
.
8. Specify a valid IP address for the system.
9. Specify the Name Service you want the system to use.
10. Specify the name of the Domain that the system will be a part of.
hardwire:\:dv=/dev/term/a:br#9600:el=^C^S^Q^U^D:ie=%$:oe=^D
lom> poweron
SysAdmin.book Page 61 Friday, March 30, 2001 2:38 PM