Sun Microsystems Netra t1 100, User And Administration Manual

Page: 90 / 154

68 Netra t1 User and Administration Guide • June 2000
7. Power up the Netra t1 Model 100/105. When you do this, the system will
automatically attempt to boot from the network.
8. Follow the instructions on the console for a standard installation.
For more information, refer to the documentation provided with Solaris 2.6 (5/98).
Installing Solaris release 7 or 8
The Netra t1 system is supplied with Solaris 7 (11/99) already installed and patched.
To re-install Solaris 7 (for example, after having previously installed Solaris 2.6) or to
install Solaris 8, follow the instructions in the documentation provided with your
Solaris 7 or 8 CD. These installations are standard procedures and do not involve
supplementary installation CDs.
If you are installing Solaris 7, we recommend you install the version dated 11/99 or
later.
Note –
The Netra t1’s factory-installed software includes the ‘Lights-Out’
Management software. If you install a new operating system and you want to use
the ‘Lights-Out’ Management facilities described in Chapter 9, you must re-install
the ‘Lights-Out’ Management software. This is available on a CD (part number:
X6972A) from your Sun Enterprise Services representative.
The Patches You Need
TABLE 8-1
tells you which patches you need to apply to run the different versions of
Solaris on a Netra t1 Model 100/105. The latest versions of each patch are available
from your local Sun Enterprise Services representative or from SunSolve:
http://www.sun.com/sunsolve
Note – If you are using the factory-installed system software, you do not need to
apply any patches. They have been applied for you already.
SysAdmin.book Page 68 Friday, March 30, 2001 2:38 PM