Sun Microsystems Netra t1 100, User And Administration Manual

Page: 40 / 154

18 Netra t1 User and Administration Guide • June 2000
▼
To Install the Strain Relief Housings
1. Take the DC connector and insert the bottom portion of the strain relief housing
into the notch on the DC connector until it snaps into place (see
FIGURE 3-5
).
Make sure the strain relief housing snaps into place on the DC connector; you will
not be able to complete the assembly correctly if the strain relief housing is not
snapped into place.
FIGURE 3-5
Inserting the Bottom Portion of the Strain Relief Housing
2. Route the three wires coming from the DC power source through the opening at
the end of the bottom portion of the strain relief housing (see
FIGURE 3-6
).
SysAdmin.book Page 18 Friday, March 30, 2001 2:38 PM