Sun Microsystems Netra t 1120, Service Manual, Page: 89 / 148

Chapter 9 Storage Devices 9-7
4. Lower the front cover.
5. Remove the ESD plate.
See Section 9.1.1 “To Remove a Hard Disk Drive” on page 9-2.
6. If necessary, remove the blanking plate.
7. Partially insert the drive with the release button at the top right hand side.
8. Connect the SCSI and power cables to the rear of the drive.
9. Push the drive fully into the drive assembly (
FIGURE 9-2
on page 9-6).
10. Using a No.1 Phillips-head screwdriver, replace the four captive screws securing
the drive to the drive assembly.
11. Replace the ESD plate.
12. Replace the top cover.
See Section 7.3 “To Replace the Top Access Cover” on page 7-6.
13. Remove the wrist strap.
14. Replace the front cover.