Sun Microsystems Netra t 1120, Service Manual, Page: 31 / 148

Chapter 3 Power-On Self-Test 3-5
3.4.1
diag-level
Variable Set to
max
When the
diag-level
variable is set to
max
, POST enables an extended set of
diagnostic-level tests. This mode requires approximately four and a half minutes to
complete.
CODE EXAMPLE 3-1
identifies a typical serial port A POST output with
diag-level
set to
max
.
Note –
xxxx placeholders used in table entries represent numeric values which can
change without notice.
CODE EXAMPLE 3-1 diag-level
Variable Set to
max
Hardware Power ON
Master CPU online
Master Version: 0000.0000.1700.1120
Slave Version: 0000.0000.1700.1120
CPU E$ (M) 0000.0000.0020.0000 (S) 0000.0000.0020.0000Button Power
ON
Master CPU online
Master Version: 0000.0000.1700.1120
Slave Version: 0000.0000.1700.1120
CPU E$ (M) 0000.0000.0020.0000 (S) 0000.0000.0020.0000
Probing keyboard Done
%o0 = 0000.0000.0000.4001
Executing Power On SelfTest
0>
0>@(#) Sun Ultra 60(UltraSPARC-II 2-way) UPA/PCI POST 1.0.8 01/21/
1998 02:36 PM
0>INFO: Processor 0 is master.
0>
0> <00> Init System BSS
0> <00> NVRAM Battery Detect Test
0> <00> NVRAM Scratch Addr Test
0> <00> DMMU TLB Tag Access Test
0> <00> DMMU TLB RAM Access Test
0> <00> IMMU TLB Tag Access Test
0> <00> IMMU TLB RAM Access Test
0> <00> Probe Ecache
0>INFO: CPU 296 MHz: 2048KB Ecache
0> <00> Ecache RAM Addr Test
0> <00> Ecache Tag Addr Test