Sun Microsystems Netra t 1120, Service Manual

Page: 84 / 148

9-2 Netra t 1120/1125 Service Manual • August 1998
9.1 Hard Disk Drive
9.1.1 To Remove a Hard Disk Drive
See
FIGURE 9-1
on page 9-3.
Caution –
Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
1. Attach the wrist strap.
See Section 7.1 “To Attach the Wrist Strap” on page 7-1.
2. Power off the system and remove the input power connector(s).
See Section 6.2 “To Power Off the System” on page 6-3.
3. Open the front access cover.
4. Remove the front ESD screen, using a No.1 Phillips-head screwdriver to undo the
two captive screws.
5. Push the handle latch to the right to open the drive handle.
6. Extend the drive handle to disconnect the drive from the system.
7. Holding the drive handle, remove the drive from the drive bay.
8. The hard disk drive rear connector is disconnected when the drive is ejected.
9. Place the drive on an ESD mat.
!