Sun Microsystems Netra t 1120, Service Manual, Page: 71 / 148

8-1
C H A P T E R
8
Power Subassemblies
This chapter contains procedures to remove and replace the power subassemblies of
the Netra t 1120/1125 system unit enclosure.
8.1 Power Supply
8.1.1 To Remove the Power Supply
Caution –
Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
1. Attach the wrist strap.
See Section 7.1 “To Attach the Wrist Strap” on page 7-1.
2. Power off the system and remove the input power connector(s).
See Section 6.2 “To Power Off the System” on page 6-3.
Caution –
When removing the power supply, attach the copper end of the wrist
strap to the system unit chassis, not to the power supply.
!
!