Sun Microsystems Netra t 1120, Service Manual

Page: 87 / 148

Chapter 9 Storage Devices 9-5
9.2 Removable Media Drive
9.2.1 To Remove a Removable Media Drive
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
1. Attach the wrist strap.
See Section 7.1 “To Attach the Wrist Strap” on page 7-1.
2. Power off the system and remove the input power connector(s).
See Section 6.2 “To Power Off the System” on page 6-3.
3. Remove the top cover.
See Section 7.2 “To Remove the Top Access Cover” on page 7-4.
4. Remove the ESD plate.
See Section 9.1.1 “To Remove a Hard Disk Drive” on page 9-2.
5. Undo the four captive screws on top of the removable media drive assembly using
a No.1 Phillips-head screwdriver.
6. Partially remove the CD-ROM/tape drive from the assembly.
7. Disconnect the SCSI and power connectors from the rear of the drive.
8. Remove the drive from the chassis and place it on an ESD mat.
!