Sun Microsystems Blade X6275 M2, Service Manual

Page: 22 / 136

Powering On and Off the Server Module
The section contains the following procedures for powering on and powering off the server
module:
Note –
The procedures in this section assume that you are working locally, at the server module.
For information about powering the server remotely, refer to the ILOM documentation
included online with the server module's documentation collection.
■
“How to Power the Server Module to Standby Power Mode” on page 22
■
“How to Power On the Server Module to Full Power Mode” on page 23
■
“How to Power Off the Server Module” on page 23
▼
How to Power the Server Module to Standby Power
Mode
Use this procedure to place the server in to the non-operational standby power mode.
Note –
The Sun Blade X6275 M2 Server module is a dual-node server. If necessary, use this
procedure for both nodes.
■
This task assumes that you are at the server module working locally.
■
See “Power Modes” on page 19 .
■
See “Power Button and Power OK LED” on page 20 .
To place the server module in standby power mode, do one of the following:
■
If the server module is in a full power mode state, power off the server module. See “How to
Power Off the Server Module” on page 23 .
Note –
Powering off the server module from full power mode places the server module in
standby power mode.
■
If the server module has been removed from the chassis, ensure that the chassis is powered
on and install the server module into its slot in the chassis. See
“How to Install the Server
Module in the Chassis” on page 35 .
Before You Begin
●
Powering On and Off the Server Module
Sun Blade X6275 M2 Server Module Service Manual • March, 2013 22