Sun Microsystems Blade X6275 M2, Service Manual

Page: 128 / 136

▼
How to Install the Server Module Filler Panel
Extend the filler panel ejector lever to its fully open position.
To release the lever, squeeze the green latch and rotate the lever outwardly away from the front
of the server module.
Slide the filler panel into the slot until it stops.
The filler panel is not yet flush with the front of the chassis.
Ensure that the pawl on the end of the lever is aligned with the slot in the chassis sidewall.
Rotate the lever toward the front of the filler panel and push it flat against the filler panel until it
locks into place.
This action draws the filler module into that chassis setting it flush with the front of the chassis.
“How to Remove a Server Module Filler Panel” on page 127
1
2
3
4
See Also
Removing and Installing a Server Module Filler Panel
Sun Blade X6275 M2 Server Module Service Manual • March, 2013 128