Subaru Crosstrek 2022, Owner'S Manual

Page: 129 / 475

&
Alarm system operation
When the alarm system is armed, it is
triggered by the opening any of the doors,
the rear gate (5-door models) or trunk lid
(sedan).
The alarm system will activate the follow-
ing alarms when triggered.
.
The vehicle
’
s horn will sound for 30
seconds.
.
The hazard warning flashers will flash
for 30 seconds.
If any of the doors or the rear gate/trunk lid
remains open after the 30-second period,
the horn will continue to sound for a
maximum of 3 minutes. If the door or the
rear gate/trunk lid is closed while the horn
is sounding, the horn will stop sounding
with a delay of up to 30 seconds.
NOTE
The alarm system can be set to trigger
the illumination of the following interior
lights.
.
Map lights (illuminates only when
the map lights switch is in the
“
DOOR
”
position)
.
Dome light (illuminates only when
the dome light switch is in the
“
DOOR
”
position)
.
Cargo area light (illuminates only
when the cargo area light switch is in
the
“
DOOR
”
position)
The notifications regarding the map
lights, dome light and cargo area light
are deactivated as the factory setting. A
SUBARU dealer can activate the sys-
tem. Contact your SUBARU dealer for
details.
&
Arming the system
The alarm system becomes armed when
the following operation is performed.
1. Close all windows and the moonroof (if
equipped) and turn the ignition switch to
the
“
OFF
”
position.
2. Carry the key and get out of the
vehicle.
3. Lock the doors using any of the
following methods.
.
Locking using the remote keyless
entry system. For details, refer to
“
Remote keyless entry system
” F
2-
19.
.
Locking using the keyless access
function (if equipped). For details, refer
to
“
Locking with the door lock sensor
”
F
2-10.
.
Locking using the power door lock-
ing switch. For details, refer to
“
Lock-
ing using power door locking switch
”
F
2-24.
NOTE
Security indicator light
All doors and the rear gate (5-door
models) will lock, an electronic chirp
will sound once, the hazard warning
flashers will flash once, and the secur-
ity indicator light will start flashing
rapidly.
4. Approximately 30 seconds later, the
system will enter surveillance state.
When the system is in surveillance state,
the security indicator light will then flash
slowly (twice approximately every 2 sec-
onds), indicating that the system has been
armed for surveillance.
Keys and doors/Alarm system
–
CONTINUED
–
2-27