Subaru Crosstrek 2022, Owner'S Manual

Page: 123 / 475

flashers in the above cases can be set
to
“
On
”
or
“
Off
”
by a SUBARU dealer.
Consult your SUBARU dealer for de-
tails.
&
Locking the doors
Press the lock/arm button to lock all doors
and rear gate (5-door models). An electro-
nic chirp will sound once and the hazard
warning flashers will flash once.
If any of the doors (or the rear gate/trunk
lid) are not fully closed, the following will
occur to alert you that the doors (or the
rear gate/trunk lid) are not properly closed.
.
an electronic chirp sounds five times.
.
the hazard warning flashers flash five
times.
When you close the door, it will automa-
tically lock and then the following will
occur.
.
an electronic chirp sounds once.
.
the hazard warning flashers flash once.
&
Unlocking the doors
Press the unlock/disarm button to unlock
the driver
’
s door. An electronic chirp will
sound twice and the hazard warning
flashers will flash twice. To unlock all
doors and the rear gate (5-door models),
briefly press the unlock/disarm button a
second time within 5 seconds.
NOTE
If the interval between the first and
second presses of the unlock/disarm
button (for unlocking of all of the doors
and the rear gate) is extremely short,
the system may not respond.
&
Opening the trunk lid
(sedan)
Press and hold the trunk lid opener button
to open the trunk lid. An electronic chirp
will sound twice and the hazard warning
flashers will flash twice.
&
Unlocking the rear gate
(5-door models)
Press the rear gate unlock button to
unlock the rear gate.
An electronic chirp will sound twice and
the hazard warning flashers will flash
twice.
&
Vehicle finder function
Use this function to find your vehicle
parked among many vehicles in a large
parking lot. Provided you are within 30 feet
(10 meters) of the vehicle, pressing the
lock/arm button three times in a 5-second
period will cause your vehicle
’
s horn to
sound once and its hazard warning
flashers to flash three times.
NOTE
If the interval between presses is too
short when you press the lock/arm
button three times, the system may
not respond to the signals from the
remote transmitter.
&
Sounding a panic alarm
To activate the alarm, press the
“
PANIC
”
button once.
The horn will sound and the hazard
warning flashers will flash.
To deactivate the panic alarm, press any
button on the remote transmitter. Unless a
button on the remote transmitter is
pressed, the alarm will be deactivated
after approximately 30 seconds.
&
Selecting audible signal op-
eration (models without
“
keyless access with push-
button start system
”
)
Using an electronic chirp, the system will
give you an audible signal when the doors
lock and unlock. If desired, you may turn
the audible signal off.
Perform the following steps to deactivate
Keys and doors/Remote keyless entry system
–
CONTINUED
–
2-21