Subaru Crosstrek 2022, Owner'S Manual

Page: 285 / 475

and turn to the
“
START
”
position to restart
the engine.
&
Entering the vehicle follow-
ing remote engine start shut-
down
An alarm trigger may occur if the vehicle is
opened by the remote keyless entry
transmitter within a few seconds immedi-
ately following remote engine start shut-
down.
&
Pre-heating or pre-cooling
the interior of the vehicle
Before exiting the vehicle, set the tem-
perature controls to the desired setting
and operation. After the system starts the
engine, the heater or air conditioning will
activate and heat or cool the interior to
your setting.
&
Remote transmitter program
(Remote engine starter
transceiver)
New transmitters can be programmed to
the remote engine start system in the
event that a transmitter is lost, stolen,
damaged or additional transmitters are
desired (the system will accept up to eight
transmitters). New remote engine start
transmitters can be programmed accord-
ing to the following procedure.
1. Open the driver
’
s door (the driver
’
s
door must remain opened throughout the
entire process).
2. Depress and hold the brake pedal.
3. Turn the ignition switch to
“
ON
”
then
“
LOCK
”
/
“
OFF
”
, back to
“
ON
”
then
“
LOCK
”
/
“
OFF
”
, back to
“
ON
”
then
“
LOCK
”
/
“
OFF
”
,
then back to
“
ON
”
again and leave the
ignition
“
ON
”
throughout the programming
process.
4. The system will flash the side marker
lights, tail lights and parking lights and
honk the horn three times, indicating that
the system has entered the transmitter
learn mode.
5. Press and release the
“ ”
button on
the transmitter that you want to program.
6. The system will flash the side marker
lights, tail lights and parking lights and
honk the horn one time, indicating that the
system has learned the transmitter. Upon
successful programming, the remote start
confirmation transmitter button will flash
one time.
7. Repeat step 5 for any additional
transmitters (the system will accept up to
eight transmitters).
8. The system will exit the transmitter
learn mode if the key is turned to the
“
LOCK
”
/
“
OFF
”
position, the door is closed
or after 2 minutes.
&
System maintenance
NOTE
For remote engine starter transceiver:
In the event that the vehicle
’
s battery is
replaced, discharged or disconnected,
it will be necessary to start the vehicle
a minimum of one time using the key
prior to activating the remote engine
start system. This is required to allow
the vehicle electronic systems to re-
synchronize.
!
Changing the battery
CAUTION
.
Do not let dust, oil or water get on
or in the remote engine start
transmitter when replacing the
battery.
.
Be careful not to damage the
printed circuit board in the re-
mote engine start transmitter
when replacing the battery.
.
Be careful not to allow children to
touch the battery and any re-
moved parts; children could
swallow them.
.
There is a danger of explosion if
Starting and operating/Remote engine start system (dealer option)
–
CONTINUED
–
7-19